![]() ![]() ![]() Once a number of objects have been selected, the Remove Boundary Objects button becomes active and can be used to remove objects from the selection. If the selected objects form a closed area, AutoCAD will hatch that area. The Select Boundary Objects allows a number of objects to be selected. The Pick Points method allows a point to be clicked on the screen, AutoCAD will then attempt to find objects that enclose an area. ![]() There are two different options for identifying areas to hatch, the Pick Points method and the Select Boundary Objects method. The Boundaries panel from the Ribbon Hatch Creation tab controls how the area to be hatched is selected. In this case, the Hatch tool is active so, the Hatch Creation tab is added to the end of all the Ribbon tabs. Note: A contextual Ribbon panel is one that will show when you have a specific tool selected. The Ribbon Hatch Creation contextual tab will show. Hatch is created from the Ribbon Home tab > Draw panel, by clicking the Hatch tool.Ĭommand line: To start the Hatch tool from the command line, type “ H” and press. The double pattern indicates brickwork, the single line hatching indicates blockwork and the floor pattern indicates concrete. In the construction industry, hatches are most commonly used to describe materials in elevations and sections.Ĭertain hatch patterns are considered standard patterns for specific materials. Hatches can be patterns or solid fills and are used to identify different parts of a building. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |